Crate&Barrel Leisure Instructions D'installation page 5

Leisure
Power Recliner Sofa / Canapé Inclinable Électrique / Sofá Reclinable Eléctrica
MAINTENANCE:
� Check the power supply cord and output cord for damages before use
� Check the enclosure for cracks or other damages before use
� Do NOT operate the CPS if the connection cords or the enclosure are damaged. A damaged CPS cannot be
repaired.
� Disable the damaged CPS in an obvious way, so that it won't represent a hazard to others. Please dispose of a
damaged CPS according to the local regulations
� The CPS may be cleaned with a slightly damp towel, but should never have direct contact with water. Ensure the
CPS is dried completely before plugging in and operating
� Do NOT use any solvents (petrol, alcohol, etc.) for cleaning the CPS. The case of the CPS may be damaged and
explosive vapors may develop
� Do NOT use any sharp edged objects for cleaning
� This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
� Children should be supervised to ensure that they do not play with the appliance
� If the supply cord is damaged, it must be replaced by qualified professionals in order to avoid a hazard.
� Fuses should only be replaced by qualified professionals
NOTE:
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against electromagnetic interference in a
residential installation: This equipment can radiate radio frequency energy and, if not installed and used in reception,
which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
� Reorient or relocate the receiving antenna
� Increase the separation between the equipment and the receiver
� Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
� Consult an experienced radio/TV technician for assistance
Made in China - r05 800.967.6696 | crateandbarrel.com 5/9