Publicité
Les langues disponibles
Les langues disponibles
14
16
E
8
F
2
G
15
17
7
2
1
3
6
1
Mount the clamp bracket (14) from underneath (see circled
diagram) against the support plate (17) using screws (16).
Fit nuts (15) and tighten firmly.
Mounting the guide wheel
Push screw (1) through the rectangular hole on the guide trol-
ley (2) (align the sides of the screw with the sides of the hole).
Mount guide wheel (3), compression washer (4), washer (5)
and nut (6).
6
Tighten nut (6) so that the guide wheel can be turned on the
5
guide trolley.
4
Push second screw (8) through the long hole on the guide
trolley and the hole on the guide wheel.
Tighten quick-action lever (7).
NOTE:
Pulling the quick-action lever cancels out the screw effect. It
can be tightened up by pulling the lever again.
Mounting the water tank
5
Unscrew the star handle (1) and remove control shaft (2).
Mount holding bracket (3) and control shaft (2) with star han-
dle (see picture).
Position water tank (4) on holding bracket (3).
Take the connection hose (7) through the rear handle area of
the power cut and place onto the coupling element of the wa-
ter set.
4
NOTE:
Adjust holding bracket (3) so that the water tank is flush with
the guide trolley when working.
Pull the valve knob (6) to start the water flow.
3
NOTE:
To fill up, take hold of the water tank by the handle and pull out
upwards. Unscrew cap (5) and fill the water tank with clean
water. Do not allow dirt to get into the tank; it could damage
the O-ring on the closure valve or block the sprinkler nozzles.
7
7
Publicité
