Publicité
Les langues disponibles
Les langues disponibles
Storage, assembly, use and maintenance instructions
Storage
Store the package flat, in a dry and airy place.
Protect against direct weather conditions such as rain, hail, sunshine.
Preparation for assembly
Before starting the assembly, read the contents of the assembly instructions and check the completeness of the
set and the quality of the components. In case of any irregularities, contact the seller immediately.
Lay out the elements of the set on a clean surface in order to identify them according to the assembly instructions
and to avoid possible damage, dirt or scratches.
Do not walk on the PVC panels as this may damage them.
Equip yourself with the tools and accessories needed for proper installation.
The garage is designed for mounting on post anchors, which are not included in the kit -
they should be selected depending on the type of base (screwed to concrete, poured, hammered).
The place of installation should provide adequate stability and rigidity of the anchor-substrate connection.
It is recommended to use concrete anchors, which will be fixed to the point spouts (concrete foundation alloys)
or to the foundation.
It is not recommended to install anchors on paving stones. In such a case, a part of the paving block should be
disassembled and the point spouts should be prepared or the driving anchors should be used.
Assembly
The assembly should be done by 2-3 adults.
Estimated installation time 6-12 h (this time does not include preparation/leveling of the surface or making
foundations 8-24 h).
The total assembly time depends on the original condition of the surface and how the garage is anchored.
PVC roof panels have two sides with a rough and smooth structure.
Please make sure that the roof panel is screwed down with a smooth surface!
The outermost PVC roof panels should be laid with a distance from the planks as shown in Figure 6.
Before screwing the panels, they must be drilled. The diameter of the hole should be 2x larger than the screw
diameter.
Do not walk on PVC boards! To screw the screws on the central part of the roof, you must provide planks or
polystyrene boards to distribute the weight of the installer. It is also possible to install the PVC boards using an
appropriately high ladder without climbing onto the boards, which is recommended by Stelmet.
Special care must be taken when installing PVC panels!
In places where wood is joined with screws, a hole should be made with a diameter 2 mm smaller than the
diameter of the screw used. This is necessary to prevent the wood from cracking when screwing.
All assembly and construction works should be performed with special care and health and safety rules.
Publicité
