Publicité
Les langues disponibles
Les langues disponibles
( 9 ) Press <GREEN> button to enter Manual Scan Page.
(10) Press <Up/Down> button to select Frequency option.
(11) Press <0~9> button to input the Frequency value.
(12) Press <Up/Down> button to select Bandwidth option.
(13) Press <Left/Right> button to set Bandwidth value.
(14) Press <OK/Exit> button to start scan or exit. See Figure 2.
2.Menu Operations
Once the channel scan is finished and all the channels are stored into the
database,
you can start to watch the digital terrestrial TV channel or listen to the radio
broadcast, some typical operations are given in this chapter.
2.1 Main Menu
Main Menu for operating a lot of functions.
(1) Press <Menu> button to enter Main Menu.
(2) Press <Info> button to display the version information of STB.
2.2 SETUP
Set the system settings of STB.
2.2.1 Installation
Set the receiving and playing program settings of STB.
2.2.1.1 Antenna Setting
Set the antenna power on or off to supply +5V power to antenna or not.
Note: The default is OFF, set this option to
to an active antenna which amplifies the received RF signal, otherwise please set
it to
OFF .
2.2.1.2 Country Setting
Set the country for Auto Scan, Manual Scan and Time Zone.
Note: Change the Country Setting will automatically change the default Time
Zone and set the default Frequency and Bandwidth for Auto Scan.
MANUAL SCAN
Channel No.
Frequency
Bandwidth
Strength
65 %
Quality
94 %
Move
Move
OK
Edit
Figure 2. Manual Scan edit
6
01/01/2008 02:19
CH .21
474.000 Mhz
8 Hz
Scan
Exit
ON
only if this STB is connected
Publicité
