Panasonic EH-HS95 Mode D'emploi page 16

Cleaning
Clean the straightener after it has cooled and with the plug
removed from the household outlet.
Cleaning the nanoe™ Outlet (H)
● Clean the nanoe™ Outlet about once per month.
● This maintenance allows the straightener to sustain the
generated level of nanoe™ over a long period.
1
1
Shut the Iron Plate (G) with the Open/Close
Lock (D).
2
2
Damp the end of the Cleaning Brush (L)
(included) with store-bought purifi ed water or
tap water.
3
3
Deeply insert the
Cleaning Brush (L)
(included) into the
TM
nanoe Outlet (H).
Brush three fl at portion
( ) and pin-shaped
a
portion ( ) by moving
b
the Cleaning Brush (L)
(included) right and left
for about ten times.
TM
(nanoe Outlets are
located on both sides.)
• Instead of using the Cleaning Brush, thin cotton swabs
(for babies) can also be used.
16
All manuals and user guides at all-guides.com
Cleaning the straightener
● When this unit has become dirty or styling products, etc.
have gotten onto it, please soak a rag in soapy water, wring
it out, and wipe the unit clean.
● Do not use alcohol, thinner, benzine or remover.
Doing so may crack or discolor the surface of the
straightener.
Troubleshooting
● Sparks are generated inside the nanoe™ Outlet.
● The nanoe™ Outlet emits a noise (crackling noise).
Dust, styling products, etc. are
adhered to the pin-shaped
portion where nanoe
generated.
Clean the nanoe
a
b
remove any adherents.
(On both sides)
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.
Problem
Possible cause
Your hair is too wet.
TM
is
Action
TM Outlet to Dry your hair until it is slightly
wet.