Memorex MPH6925 Manuel Du Propriétaire page 6

UC372BH (MPH6925) OM ENG
Making and Receiving Calls
When the phone rings, remove the handset from
Answer call
the base. (Instant Talk)
1. Remove the handset from the base and press TALK.
2. The TALK/BATT LED flashes and lights.
Make call
3. Listen for the dial tone.
4. Dial the number.
Press OFF or return the handset to the base.
Hang up
(Auto Disconnect)
1. Remove the handset from the base and press TALK.
2. Listen for the dial tone.
Redial
3. Press REDIAL/PAUSE to dial the last
dialed number.
Ringer Mute None
Storing a Number in Memory
Your MPH 6925 phone has 10 memory locations for
storing important telephone numbers.
1. Remove the handset from the
base and press MEMORY.
The TALK/BATT LED flashes
and you hear a beep.
2. Enter the phone number you want to store
(up to 16 digits).
You have 30 seconds after pressing
MEMORY to enter the number you wish to
store. Otherwise, an error tone will sound.
3. Press MEMORY and enter a number (0-9) on the
keypad for the memory location you want to use.
You hear a long beep and the TALK/BATT LED goes
out indicating the number has been stored successfully.
If you select any keys other than 0-9, the handset will
beep rapidly and no number will be stored.
You cannot store numbers in SPEED DIAL.
Refer to "One-Touch Dialing".
3/12/02 11:24 AM
Using Your Phone
Handset on Base
Entering a Pause in Memory Dialing
If you would like to use a phone
number stored in memory to
access voice mail, for example,
you can store a pause in the
phone number sequence.
To use this function, follow steps 1
and 2 in "Storing a Number in Memory", then press the
REDIAL/PAUSE button on the handset to place a pause
in the phone number sequence.
Follow the remaining steps in the "Storing a Number in
Memory" section to complete the operation.
6
Page 6
Handset off Base
Press TALK, any number key, ✱/TONE, or #.
1. Pick up the handset and press TALK.
2. The TALK/BATT LED flashes and lights.
3. Listen for the dial tone.
4. Dial the number.
Press OFF or return the handset to the base.
(Auto Disconnect)
1. Pick up the handset and press TALK.
2. Listen for the dial tone.
3. Press REDIAL/PAUSE to dial the last
dialed number.
Press OFF when ringing.
Remember, the phone number you wish to
store cannot have more than 16 digits,
including the pause. (The PAUSE button
counts as one digit.)