PROBLEM
Lint on clothes
Garments still wrinkled
after Wrinkle-Care
Odors remain in
clothing after Refresh.
Water drips from
nozzle when Steam-
Care starts
Sprayed water is not
visible during Steam-
Care
Extended time
Information codes
Information codes may be displayed to help you better understand what is occurring with your Dryer.
ERROR DISPLAY MEANING
The thermistor resistance is very low
tE
or high.
Invalid heating Temp when the dryer
HE
is running.
dE
The door is open
Invalid state of key.
bE2
Invalid power source frequency
FE
Electronic Control Problem
9E1
(Over Voltage Error)
Electronic Control Problem
AE
(Communication Error)
EEE
Invalid state of Eeprom communication Call for service.
dF
Invalid door.
For any codes not listed above, call 1-800-SAMSUNG (726-7864)
DV6000HA_DC68-03380A.indd 35
SOLUTION
•
Make sure the lint filter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the filter
during the cycle.
•
Some fabrics are lint producers (for example, a fuzzy white cotton towel)
and they should be dried separately from clothes that are lint trappers (for
example, a pair of lack linen pants)
•
Divide larger loads into smaller loads for drying
•
Check pockets thoroughly before washing and drying clothes.
•
Small loads of 1 to 4 items work best.
•
Load fewer garments.Load similar-type garments.
•
Fabrics containing strong odors should be dried in a normal cycle.
•
This is steam condensation. The dripping water will stop after a short time.
•
Sprayed water is difficult to see when the door is closed.
•
English - 35
SOLUTION
Clean the screen or vent.
If the problem continues, call for service.
Call for service.
Clean the door and then restart.
If the problem continues, call for service.
Make sure a button is NOT being pressed
continuously. Try restarting the cycle.
If the problem continue, call for service.
Try restarting the cycle.
If the problem continues, call for service.
Call for service.
Call for service.
Call for service.
2013-12-02
3:54:37