Signature Design by Ashley Screen Time Serie Mode D'emploi page 4

3. To install the back, align the female brackets in the back with the male brackets in the chair base, slide the back down on the base.
See Figure B Push down on the top of the back to lock the back into posi�on. You will hear a click from each side of the chair to
ensure the back is locked in properly.
Figure B
4. If your model has back wings, align the male the female brackets and slide the wing down into place, See Figure C. Please Note
there is a label on the brackets. Please assemble them as 1-1 and 2-2.
Figure C
1
5. Connect the Power Transformer cable to the corresponding plug coming from the back of the chair Figure A #3
6. Connect the Power Cord into the Power Transformer Figure A #4
7. Connect the power cord into an electrical outlet near where the chair will be used Figure A #5
WARNING: Clear area below chair before opera�ng to reduce risk of injury or death.
If the chair is not func�oning, check the plug in and connec�on of the cords first (The order is A-B-C), see the Figure A.
Be sure cords are clear from the chair prior to opera�on.
TROUBLE SHOOTING
-PROBLEM
Chair will not operate
-POSSIBLE FACTORS
Transformer may not be connected
-SOLUTIONS
Ensure both wire from the chair and the power cord is firmly conneed to the transformer
®
SIGNATURE DESIGN BY ASHLEY All Rights Reserved.
Snap
Feb. 2022 00365B Page 4 of 17