Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS - Illustration 1
Model
ILBLP CP10
ILBLP CP15
CAUTION: Before installing, make certain A.C. power is off and the Threaded Body Test Switch (TBTS) is disconnected.
STEP 1 - MOUNTING THE ILBLP CP HE SD
The ILBLP CP HE SD is designed to be installed inside the
luminaire channel or wireway. Place the unit on the mounting
surface and fasten through the mounting slots using serrated
head screws (U3840).
ILBLP NORMAL DRIVER AND LED LOAD CONNECTIONS
STEP 2 - WIRING TO THE LED LOAD AND NORMAL DRIVER
Refer to the appropriate wiring diagram below. Make sure all connections are in accordance with NEC and any other
local requirements.
WHT/RED
OR RED/WHT
STEP 3 - INSTALLING THE THREADED BODY TEST SWITCH (TBTS)
EMERGENCY
DRIVER
TBTS
A. Locate a suitable location for the TBTS and
cable that is visible outside the fixture. Drill
or punch a 1/2" diameter hole in the fixture
wall or wireway cover. Insert the TBTS into
the hole so that the LED test button/pilot
light is located outside of the fixture.
Remote Mounting - The TBTS may be remote mounted from the fixture up to 25 feet. Before extending the TBTS wires,
ensure that AC Power is off and the TBTS has been disconnected. To extend the TBTS wires, splice the TBTS leads
between the test switch and connector and install a patch cable (minimum 18 AWG) of the desired length to the spliced ends.
Be sure to observe wire color. After extending the TBTS wires, follow the installation procedure (steps A, B, and C) above to
recconnect the TBTS.
Input Voltage (Min - Max)
120-277 VAC
120-277 VAC
INSTALLATION INSTRUCTIONS
AC (NORMAL)
DRIVER
WHITE
IOTA ILBLP
EMERGENCY DRIVER
CHANNEL COVER
B. Secure the TBTS using the
Output Voltage (Min - Max)
15-55 VDC
20-55 VDC
LED OUTPUT (-)
LED OUTPUT (+)
RED (+)
BLUE (-)
VIOLET/WHITE (+)
YELLOW
LEDCODE (+)
BROWN
LEDCODE (-)
LUMINAIRE HOUSING
TBTS NUT
TBTS nut.
Page 2
Minimum Operation
LED INPUT(-)
LED
LED INPUT (+)
LOAD
Cap unused
!
LEDCODE wires
C. Connect and fully engage the TBTS
Connector to the TBTS Socket. Ensure
the TBTS Connector is properly seated
ilblp_tbts_normal-driver-and-load-only.eps
in the TBTS Socket, then mark the TBTS
location on the fixture with the TBTS Label
and apply the SD Status Indicator Sticker.
90 Minutes
90 Minutes
Publicité
