Swagman X Mount Mode D'assemblage

MOUNTING INSTRUCTIONS
• Locate the wall studs behind the drywall (diagram 1).
They are usually 16" apart. A stud finder can be used to
find the studs. The rack must be mounted into the wall
stud, as the drywall may not be strong enough to hold
the weight of a bike rack.
• Position the main assembly # 1 so that it is level as shown
in diagram 1. Ensure that the XMount is mounted in a
position that allows for easy access of the bike rack. You
may want to use the XMount for storage of one bike.
• Mark the location of the 3 holes on the main assembly,
and drill 1/8" guide holes (diagram 2).
• Attach the rack using 3 supplied screws and washers
(diagram 3).
• Insert receiver piece (part A) into the main bracket
assembly (diagram 4). NOTE: One side has a nut welded
on the bracket. This side goes down.
• Insert the bolt and washer through the main assembly
into the receiver piece (diagram 4). Tighten the bolts
securely.
• The bike rack can now be inserted into the XMount. The
pin is used to hold the rack in the outward position
(diagram 5).
• NOTE: The maximum weight capacity is not to exceed
100lbs. If mounting a 4-Bike rack; it must be folded in to
ensure weight distribution.
A
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
PRODUCT: 80940 XMount Bike Rack Storage • Page 1 of 1
4
INSTRUCTION SHEET
1
2
3
5
REV 03/05/11