Asus EI-102 Guide De L'utilisateur page 5

Installation
Please follow the steps below to install the PoE Injector:
1. Connect the Data In port to an RJ-45 port in your switch or hub via an
Ethernet cable.
2. Connect the Data Out port with a PoE Splitter, PD (such as router,
Access Point...etc.) or PoE Hub via an Ethernet cable.
3. Plug the power cord of the PoE Injector to the wall power jack.
Technical Specification
The following table shows the technical specification of the PoE Injector.
Standard
Connector
Network Cable
Power Input
Output Power
Operating environment
Storage Temperature
Dimension
EMI & Safety
4
All manuals and user guides at all-guides.com
LED
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-T
IEEE802.3af
DC Out: Power pin: 4,5 (V+), 7,8 (V-)
10BASE-T: 2 pair UTP/STP Cat.3,4,5 cable
EIA/TIA-568 100-ohm (100m)
100BASE-TX: 2 pair UTP/STP Cat.5 cable
EIA/TIA-568 100-ohm (100m)
System: power (green)
Input Power: 100~240V, 50~60Hz, 0.3A
48V DC, 0.3A
0˚C~40˚C; 90% Humidity (non-condensing)
0˚C~70˚C
117mm x 60mm x 35mm (L x W x H)
FCC Class B, CE, UL, cUL, CE/EN60950,
VCCI, MIC, CCC