Flama 2386FL Manuel D'instructions page 18

Thermostat Instructions
Note - Make
adjustment knob is in the MAX position
before switching on the appliance.
Once the compartment has reached
the desired temperature, slowly turn
the thermostat
counterclockwise
slight sound. Then turn the thermostat
adjustment knob clockwise until you
hear a slight sound again. The appliance/
thermostat switches on and off to ensure
the desired temperature.
To turn off the device, turn the Power &
Mode rotary knob to the off position (0).
Then remove the plug from the socket.
To adjust the thermostat knob, turn the
thermostat adjustment knob clockwise
to increase the desired temperature.
Turn counterclockwise to decrease the
temperature.
NOTE: It is normal for the appliance to
turn on and off as it maintains a fixed
temperature.
SAFETY FEATURES
The device is equipped with thermal
overload protection to prevent overheating.
The appliance switches off automatically
when it reaches an excessive temperature
and will only start again if the user restarts
the appliance (see RESET INSTRUCTIONS)
RESTART INSTRUCTIONS
Unplug the appliance and wait 15 minutes
for the appliance to cool down.
After 15 minutes, turn the device back on
and operate normally.
16
sure the thermostat
adjustment
until you hear
TROUBLESHOOTING TIPS
if your appliance unexpectedly shuts
down or stops working, this may be due to
activating one of the aforementioned safety
features to prevent overheating.
Make sure the power plug is plugged into a
knob
working electrical outlet.
a
Make sure the power plug is plugged into a
working electrical outlet.
CLEANING AND MAINTENANCE
WARNING - Always disconnect the plug
from the power outlet before carrying out
any maintenance and cleaning operations.
IMPORTANT! DO NOT IMMERSE THE
APPLIANCE IN WATER!
Clean the grill with the help of the vacuum
cleaner and the brush attachment. This will
remove grime and dirt from the inside of
the heater.
DO NOT ATTEMPT TO DISASSEMBLE THE
APPLIANCE. Clean the outside with a soft
cloth.
DANGER: Do not use gasoline, benzine,
thinner, abrasive cleaning fluids, etc. as
these will damage the convector. NEVER
USE ALCOHOL OR SOLVENTS.
To store the device, place it together with
these instructions in its original box in a
cool, dry place.
www.flama.pt