Dell PowerEdge 4220 Guide D'installation page 33

Removing and Installing the Back Door Stabilizer Bars
The top and bottom bars used to stabilize the back doors can be removed,
making it easier to route cables through the top and bottom of the rack.
1 Open the back doors.
2 Pull and hold the plungers on each side of the bar, and pull the bar up and
3 After routing your cables, replace the bars by aligning the tabs on the bars
Figure 1-17. Removing and Installing the Back Door Stabilizer Bars
1
3
Get user manuals: See SafeManuals.com
away from the rack (see Figure 1-17).
with the corresponding holes in the rack and pushing in and down until
the plungers lock into place.
back door stabilizer bar (top)
back door stabilizer bar (bottom)
1
2 plunger (2 per bar)
Installation Guide
2
3
31