Publicité
Les langues disponibles
Les langues disponibles
Figure 3
LOADING BATTERIES
1. To load the batteries, locate the compartment inside
and towards the bottom of dispenser. (See Figure 4)
2. Remove compartment cover by pushing latch and
pulling up. (See Figure 4)
Figure 4
3. Place four batteries into compartment according to
the battery diagrams on the inside. (See Figure 5)
Figure 5
4. Close the battery compartment cover.
NOTE: Three lights will appear on the dispenser
sensor when batteries are properly loaded.
PAGE 2 OF 9
All manuals and user guides at all-guides.com
MOUNTING INSTRUCTIONS CONTINUED
LOADING INSTRUCTIONS
Batteries
4. Set dispenser aside and drill into wall at four marked
locations with an appropriate drill bit. (See Figure 3)
Insert wall anchors if necessary.
5. Hold dispenser to wall so that the holes in the wall
and the dispenser match up. Insert four screws into
previously drilled holes.
LOADING PAPER TOWELS
1.
With dispenser cover open, place the roll of paper
towels on the roll holder supports located inside the
dispenser. The paper must feed over the top of the
roll. (See Figure 6)
Figure 6
2. Position the end of the roll under the transfer bar,
leaving about 1" hanging out. (See Figure 7)
Figure 7
3. Press the blue manual feed button located on front
of dispenser to feed paper through. (See Figure 8)
4. Close dispenser cover.
Transfer
Bar
0521 IH-8795
Publicité
