Publicité
Les langues disponibles
Les langues disponibles
10. Mount set 3, then remove the module-protecting Cover in the same way.
Loosen the horizontal alignment screws on bracket 3, then attach set 3 to set 6.
(Caution: Loosen the right and left horizontal alignment screws gently in turn to prevent the set from tilting and
causing damage.)
Remove the module-protecting Cover.
(The protective Cover is attached on all
four sides; at this point, only remove the
Cover on the sides where the sets meet.)
11. Use the guide fi xers provided to attach sets 3, 6 and 9 as shown below so that the sets are aligned in a perfectly
straight line.
14
All manuals and user guides at all-guides.com
3
6
9
3
6
9
<REAR>
<REAR>
2
5
8
2
5
8
1
-
1
1
1
Publicité
