Oregon LM300 Manuel D'instructions Original page 15

All manuals and user guides at all-guides.com
SYMPTOM POSSIBLE CAUSE
Height of cut too low
Grass too high
Area of cut (battery
duration) not large
Grass wet or damp
enough
Grass is dense
Cutting blade not
Cutting blade obstructed
rotating while
garden product
Blade nut/bolt loose
switched on
Excessive
Blade nut/bolt loose
vibrations/noise
Battery contacts
contaminated
No charging
The battery is defective,
procedure possible
due to a disconnection in
the battery
Mains plug of battery
The charge
charger not plugged in
control LEDs and
(properly)
respectively, do
not light up after
Socket outlet, mains
inserting the mains
cable or battery charger
plug into the socket
defective
Lawn Mower Model LM300
Troubleshooting
RECOMMENDED ACTIONS
Increase height of cut and walk slower
Increase height of cut and walk slower
Wait until grass is dry and walk slower
Increase height of cut, walk slower and cut more
frequently
Remove battery, remove safety key
Clear obstruction (always wear gardening gloves)
Remove battery, remove safety key
Tighten blade nut/bolt (15 Nm)
Remove battery, remove safety key
Tighten blade nut/bolt (15 Nm)
Clean the battery contacts by inserting and removing
the battery several times or replace the battery
Replace the battery
Insert mains plug (fully) into the socket outlet
Check the mains voltage and, if necessary, have the
battery charger checked by an authorized customer
service station for power tools
15