Télécharger Imprimer la page

Beper 40.431 Manuel D'instructions page 9

Fer à friser

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Hair curler Use instructions
HOW TO USE
1. This appliance is for domestic use only.
2. Turn on the iron with the ON / OFF switch, the operating light will turn on and the iron start to heat up, it will
be ready for use in a few seconds.
IMPORTANT: During the first few minutes of initial use, you may notice smoke and a slight smell, as well
as a buzz, this is normal.
STYLING
1. Begin by dividing the hair into thick strands of not more than 15mm and 50mm wide. The hair must be perfectly
dry, in order not to damage your hair.
2. Open the tong, take a section of hair each a time and place the end over the iron, then close the tong, making
sure that the ends extend slightly beyond the clamp.
3. Keep the strip of hair stretched as it wraps around the iron by turning the handle with one hand. Roll the curl
towards the scalp to the desired position without touching the scalp with the hot iron.
Note: When using this iron, hold your hand away from the end of the handle to prevent blockage of the cable
swing action.
4. Hold the curl in place for maximum 20 seconds.
5. Before working the curls wait until they have cooled down.
CLEANING:
Unplug the appliance and let it cool down. Iron must be clean only when it is cold. Use a soft, slightly damp cloth
to wipe the handle. Do not allow water or any other liquid to enter the appliance.
STORAGE:
Unplug the appliance and let it cool down, store it in its box or in a dry clean place, never wrap the cord around
the unit. Never hang the unit from the power cord.
Technical data:
Power: 25W
Power supply: 100-240V ~ 50 / 60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
All manuals and user guides at all-guides.com
9
EN

Publicité

loading