Zepter AqueenaPro WT-100 Manuel D'utilisation page 17

Warning!
Pay attention to the direction of the membrane; the membrane ending with an O-ring must be placed
in the bottom part of the housing.
• Do not force the RO membrane into the membrane casing; it may cause permanent damage
to the membrane shell or membrane components.
• If the RO membrane is installed correctly in the membrane housing, there is no need to force it.
Display functions
If a display icon lights up:
Working: Water purifi cation is in the progress, the device is in working mode.
Flashing light - missing inlet water source or low inlet water pressure.
Water
Source: The "Water source" icon will light up with an audible alarm (7 buzzes).
Standby: The water purifi er is in standby mode.
The fl ushing function is activated.
Flush:
Note!
If any leaks occur, all icons ("Working", " Water source", "Standby" and "Flush" icons) will
fl ash at same time along with an audible alarm.
1 2
Filter Status Display: It shows the actual fi lter status.
3 5
Green light – the fi lter works at its optimum level.
Orange light - the fi lter will soon need replacing. Please contact Zepter Service for maintenance
support.
A red light along with an audible alarm (4 buzzes) means that the fi lter must be changed immediately.
Further use of the fi lter is not recommended.
1
5 – micron PP fi lter WT-100-72
2 Pellet carbon fi lter WT-100-73
3 1 – micron PP fi lter WT-100-74
5 Coconut fi lter WT-100-75
All manuals and user guides at all-guides.com
EN
15