EUROPEAN UNION
CE DIRECTIVE
LEXON hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of Directives 2014/30/EU & 2011/65/EU.
The original EU declaration of conformity may be found at:
https://www.lexon-design.com/assets/certifications-ce-orbe.pdf
LEXON déclare que cet appareil est conforme aux exigences essentielles et aux autres
dispositions pertinentes des Directives 2014/30/EU & 2011/65/EU.
La déclaration de conformité complète EU est disponible sur :
https://www.lexon-design.com/assets/certifications-ce-orbe.pdf
UK CONFORMITY ASSESSMENT
The object of the declaration described above is in conformity with the relevant
Union harmonisation legislation.
The original UK declaration of conformity may be found at:
https://www.lexon-design.com/assets/certifications-ukca-orbe.pdf
DISPOSAL AND RECYCLING INFORMATION
After the implementation of the European Directive 2012/19/EU in the national legal
system, the following applies : electrical and electronic devices may not be dis-posed
of with domestic waste. Consumers are obliged by law to return electrical and
electronic device at the end of their service lives to the public collecting points set up
for this purpose or point of sale. Details to this are defined by the national law of the
respective country. This symbol on the product, the instruction manual or the package
indicates that a product is subject to these regulations. By recycling, reusing the
materials or other forms of utilizing old devices,
contribution to protecting our environment.
USA - FCC STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Notice:
Any changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CANADA COMPLIANCE STATEMENT
This device complies with Industry Canada license-exempt RSSs. Operation is subject
to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-005
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
you are making an important