Topmodel XPower R7 Notice D'utilisation page 2

USER'S MANUAL
FOR XPower R7 RECEIVER
1- INTRODUCTION
Please, note there are several differences between other brands and XPower receivers, especially in binding procedure
and Fail Safe settings. Before using your new receiver, please read this manual thoroughly and use the system properly
and safely. After reading this manual, store it in a safe place.
1-1 Compatibility:
FASST 2.4GHz: Air Systems ( 7CH Mode/Multi Mode)
1-2 Technical specifications:
» Number of channels: 7
» Mode: 2.4GHz PPM FASST
» Range: visual
» Operating voltage range: (DC): 3.5-10V
» Operating temperature range: -10 à +60°C
» Weight: 7.8g
» Dimensions: 37.2x23x9 (13.3)mm
2- SETTINGS
2-1 Bind procedure:
2-2 Fail Safe (F/S):
1) Turn on the transmitter R7 supports two selectable Fail Safe set-
2) Press and maintain ting options, either use native Fail Safe
pressed key F/S (with a position preset on the transmitter side or
stylus) set Fail Safe on R7.
3) Connect the battery pack 2-2-1 Use native Fail Safe position preset
4) After the red LED is off on the transmitter side:
and green LED is solid, If not disabling Fail Safe on the transmitter
release key F/S side, R7 will use native Fail Safe position
5) The binding process is preset on the transmitter side.
completed and the receiver 2-2-2 Set Fail Safe on R7 side:
is operating normally. R7 supports Fail Safe function for all
channels. Follow the steps below to set
2-3 LED status:
RED LED
Off
On
Flashing
On
All manuals and user guides at all-guides.com
/S):
table Fail Safe set- Fail Safe on R7: Fail Safe on R7:
e native Fail Safe 1) Bind the receiver fi rst and disable Fail 1) Bind the receiver fi rst and disable Fail
i id S f Safe on the transmitter side h i id
2) Set all transmitter controls to the
desired Fail Safe position
3) Press briefl y the F/S key of the receiver,
the green LED will fl ash twice indicating
the Fail Safe is set up sucessfully.
If you do not need the Fail Safe function
anymore, just re-bind the receiver to set
default Fail Safe mode.
GREEN LED MODE
On Normal
On Waiting to be bound
On Signal lost
Flashing twice Set Fail Safe
POLARITY
NOTES
No part of this manual may be reproduced in any form without prior permission. The contents of this manual are subject to change without prior
notice. While this manual has been carefully written, there may be inadvertent errors or omissions. Please contact our service center if you feel
that any corrections or clarifi cations should be made.
XPower is a commercial trademark of:
TOPMODEL S.A.S. - Le jardin d'entreprises de Sologne- 41300 SELLES SAINT DENIS - FRANCE
www.topmodel.fr / e-mail: technique@topmodel.fr / © Copyright 2012 V1-2 FEB 2012
Rx BATTERY PACK
The Rx battery pack can be plugged into
any free input of the receiver.
If you want to use all 7 channels, then use
a Y cord to connect the Rx battery pack.