Télécharger Imprimer la page

GreenTech WTLD018-06 Mode D'emploi page 8

Publicité

Les langues disponibles

Les langues disponibles

8) Do not place any object on top of the charger as it
could cause overheating. Do not place the charger
near any heat source.
9)
Do not pull on the plug of the charger to disconnect
it from the power source.
10) Make sure that the charger cable is positioned where
it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
11) Do not use an extension cord unless it is absolutely
necessary. The use of an improper extension cord
could cause the risk of fire, electric shock or
electrocution.
12) Do not use the charger if it has been subjected to a
heavy knock, dropped or otherwise damaged in any
way. Take the charger to an authorized service centre
for a check or repair.
13) Do not disassemble the charger. Take it to an
authorized service centre when service or repair is
required. Incorrect re-assembly may result in the risk
of fire, electric shock or electrocution.
14) To reduce the risk of an electric shock, unplug the
charger from the power supply before attempting to
clean it. Removing the battery alone does not reduce
the risk.
15) Do not store or use the tool and battery pack in
locations where the temperature may reach or exceed
0
0
40
C (104
F) such as alongside sheds or metal
structures in the summer.
16) The charger is designed for use from a standard
household electrical supply (120V). Do not attempt
to connect the charger to a different supply.
17) If you wish to charge a second battery pack, unplug
the charger from the main supply and leave it for at
least 15 minutes. After this time you can charge a
second battery pack.
3.
Important safety instructions for battery packs
1)
The battery pack for this tool has been shipped in a
low charge condition. You should charge the battery
pack fully before use.
2)
To ensure the longest battery life and best battery
performance, always charge the battery when the air
temperature is between 18-24
charge the battery pack when the temperature is
0
below 4ºC (40
F),or above 40
important. Failure to observe this safety rule could
cause serious damage to the battery pack.
All manuals and user guides at all-guides.com
0
0
C (65-75
F). Do not
F
0
0
C (104
C). This is
8
3)
Do not incinerate the battery pack even if it is seriously
damaged or can no longer hold a charge. The battery
pack can explode in a fire.
4)
A small leakage of liquid from the battery pack may
occur under extreme usage or temperature conditions.
This does not necessarily indicate a failure of the
battery pack. However, if the outer seal is broken and
this leakage comes into contact with your skin:
- wash the affected area quickly with soap and water.
- neutralize the liquid with a mild acid such as lemon
juice or vinegar.
If the leakage gets in your eyes:
- flush your eyes with clean water for a minimum of
10 minutes and seek immediate medical attention.
Inform the medical staff that the liquid is a 25-35%
solution of potassium hydroxide.
5)
Never attempt to open the battery pack for any reason.
If the plastic housing of the battery pack breaks open
or cracks, immediately discontinue its use and do
not recharge it.
6)
Do not store or carry a spare battery pack in a pocket,
toolbox or any other place where it may come into
contact with metal objects. The battery pack may be
short circuited causing damage to the battery pack,
burns or a fire.
7)
The battery pack utilizes nickel-cadmium cells.
Cadmium is considered to be a toxic material.
8) Use an environmentally safe disposal unit at a municipal
waste disposal centre to dispose of a damaged or
worn out battery, or return it to your dealer.
APPLICATION
Intended Use
This GREEN-TECH impact wrench is intended for driving
in and loosening screws as well as for drilling in wood,
metal, ceramic and plastic.
Check the package contents
Carefully remove each tool in the kit from the packaging.
The kit includes:
- Cordless impact driver
--Cordless drill
--2 pcs rechargeable battery packs
--Battery charger
If any parts are missing or damaged, please contact
Customer service at 800-832-7168.

Publicité

loading

Ce manuel est également adapté pour:

02325010