Beper 2PASP001 Manuel D'instructions page 11

Rechargeable vacuum cleaner Use Instructions
Crevice Nozzle
Suitable for cleaning corners, cracks or areas hard to reach. To connect and disconnect it, follow the same in-
structions of the brush (FIG. F).
Instructions for use
Connect the handle to the dust tank by aligning the upper part of the handle with the upper part of the tank then
push the lower part of the handle towards the powder tank until you hear a click (FIG. B). Connect the metallic
tube (or the chosen accessory) to the dust tank until you hear a click (FIG. C). To release the metallic tube or the
accessories, push the metal tube release button.
To turn on the appliance press the switch, to turn it off press the switch again (FIG. E).
With the +/- button placed on the handle is possible to regulate the speed.
Warning: immediately turn off the product if something gets stuck inside the suction accessory.
Cleaning the appliance
Do not use water, solvents or polishes to clean the exterior of the product, only use a dry cloth.
Make sure that no liquid enters the appliance.
Do not immerse the product in water and do not clean it in dishwasher.
How to empty the dust tank
Caution: clean the dust tank and the filter after each use; the suction power will be reduced if the
tank is full and / or the filter is clogged.
To empty the dust tank push the opening button placed under the connection between the tank and the metallic
tube. To reclose it replace the lid until you hear a click.
Push the handle release button under the handle to detach it from the tank and pull away the handle from the
tank (FIG. I).
Unscrew the upper part of the tank, the motor, by turning it counterclockwise (FIG. L).
Remove the tissue filter by using the cotton tab with "UP" sign and remove the filter housing (FIG. M).
Clean the filter and the housing in water (FIG. N).
Let the filter and the housing completely dry at the air before reassemble them.
Replace the housing and the filter inside the dust tank (FIG. O), the filter's tab must have the word "UP" facing
upwards. Screw the motor to the dust tank by turning it clockwise, until you hear a click (FIG. P).
Be sure the filter and all parts are well positioned before reconnect the dust tank to the main body.
How to clean the motorized brush
Caution: clean the brush only after detach it from the appliance.
Pull the button on the right of the brush rightward and pull it out, proceed with cleaning, let it dry and
reassemble it correctly.
Technical data
Product:
Lithium battery 22,2v, 2200 mah
Power supply:
Input: 100-240v - 50/60hz 0,5a max
Output: 26v – 0,45a
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
All manuals and user guides at all-guides.com
11
EN