Scosche MAGICMOUNT MCQD Manuel D'instructions page 6

All manuals and user guides at all-guides.com
REMOVING THE METAL PLATES
Use a thin plastic card to carefully lift the plate's adhesive
surface from the mounting surface. Slowly lift up and remove
the plate. Do not use any heat or liquids to remove the plate,
due to risk of damaging your phone. Contact Scosche
Customer Service for any additional assistance at
800.363.4490 Ext. 1 or customerservice@scosche.com.
MAGICMOUNT
TRANSMITTER
PLACEMENT
IN VEHICLES
It is possible for the transmitter
to interfere with some wireless
systems within a car. Specifically,
key fobs with immobilizers,
keyless start systems or tire
pressure monitors. Therefore,
it is recommended to test the location
of your transmitter before deciding on final placement.
Most interference issues will be minimized
by considering the following placement guidelines:
• Install transmitter a minimum of 10 inches away from the
ignition lock, key lob docking station, or any location where
the key lob might be stored while driving.
If the transmitter cannot be located a sufficient distance away
as described above, please use the following suggestions
whenever possible:
• Insert the key fob into the docking slot whenever possible
while operating the transmitter.
• Connect the transmitter to a 12 volt accessory port that is
powered only while the vehicle's ignition is in the "ACC" or
"ON" position.
• Place phone on transmitter after vehicle is started.
™
CHARGE
�
5