Taurus NIXUS Manuel D'utilisation page 23

All manuals and user guides at all-guides.com
CHARGING THE BATTERY:
- Caution: a new battery is not fully charged and must therefore be
charged before the appliance is used for the first time.
- Charge the battery at an atmospheric temperature of between 4
and 40ºC.
- Connect the charger to the jack using the socket on the appliance.
The socket is located at the lower/back part of the appliance.
- Plug the charger (M) into the mains.
- The pilot light (D) will light blue (Nixus) or white (Nixus premium)
during charging, once it is 100% charged, the color will change to
green.
- Approximately 8 hours are needed for a complete charger of the
battery. Never attempt to overcharge the battery (although it is
recommended that the first charge of the battery be of 16 hours in
duration).
- When the battery is charged disconnect the charger from the
mains supply.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has been removed.
- Before using this product for the first time, it is important to make a
full charge of batteries.
INSERTION OF A COMB GUIDE:
- Take the guide comb and insert it into the guides (Fig.1).
- To remove the guide comb, hold the comb measurement selector
low, and then pull the comb upwards. (Fig 2.)
USE:
- The appliance can be used directly connected to the mains or by
using his batteries.
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Make sure that the blades are correctly aligned.