Oursson EM1900 Manuel D'instructions page 14

Filter Holder .........................................................1 pc.
6
Instruction manual .................................................... 1 pc.
ELEMENTS OF DESIGN, Рiс. C
Control panel
Water tank's lid
Water tank, 1,2 L.
Steam control switch
Drip tray
6 Tray grid
Brew unit
7
Steam pipe
8
Cup Holder
9
Coffee Outlet
10
UTILIZATION
Control panel, Рiс.C-1
– ON/OFF button, with backlight
– button for 1 cup of coffee, with backlight
– button for 2 cups of coffee, with backlight
Steam control switch, Рiс.C-4
|
– OFF position
– Water heating position to supply steam
+
– Steam supply position
Preparation for operation
Before first use, wipe the body of the device
dry cloth. Remove the nozzle from the steam pipe by slight-
ly turning it around the axis, Pic. E-1. Wash it with warm
water and wipe dry. Water tank, tank's lid, filter
6
filter holder , measuring spoon
wash with warm water and detergent. Dry all the parts.
Before assembling or disassembling the device,
make sure that the device is unplugged.
Before first use, clean the entire system for the first
time, run 8-10 cups of water without using coffee. For
that, open the lid and fill the water tank to the MAX.
Use only clean water at room temperature 25°C. Plug
in the device.
Before turning on the coffee machine, make
sure that the steam control switch is in | (OFF)
position.
Install the filter holder (without coffee), Pic. D-4. Press
,button, in the heating process, the button indicator
will flash, when the device is ready to use, the button
indication will be lit continuously.
Press or . button. Water will start to flow
through the coffee outlet. Repeat the procedure a few
times. Let the device cool.
NOTE. Between the operational cycles, the button
indication will flash. This means that it is in a heating
process. Wait for the device to be ready for use.
14
All manuals and user guides at all-guides.com
with a soft,
,
, tray and tray grid
Order of Operation:
1. Open the tank's lid, Pic. D-2. Remove the water tank,
pulling it up, fill it with water to the MAX. You may also
add water without taking the tank out, Pic. D-1. Use only
clean, non-carbonated water at room temperature 25°C.
Do not use any other liquids, such as hot water or milk.
This may lead to the coffee machine breakage.
Do not turn on the device with empty water
tank. Make sure there is enough water in the
tank (above the MIN mark).
2. Plug in the device. Press
indication will flash while the device is heating up, and will
be lit continuously when the device is ready to use. The
presence of water in the cavity under the tank is normal.
Therefore, periodically drain it with a clean sponge.
The cup holder is heated up, when the device is
operating. Put coffee cups on it. Pic. D-4.
3. Place the ground coffee filter for 1 or 2 cups into the
filter holder. Make sure it is installed correctly, pic. D-3.
4. Place the filter holder into the brew unit. For that,
holding it with the handle to the left, bring it under the
brew unit, then insert it and turn the handle to the right,
until it locks. Let go of the filter holder handle, it will move
slightly to the left, Pic. D-4.
5. To make espresso, it is necessary to warm up the
device and filter holder. Press
the first portion of coffee.
6. After running the water, remove the filter holder by
turning it to the left.
7. Using the measuring spoon, add 1-1.5 tablespoons of
, ,
ground coffee (~7 g.) for one cup or 2 spoons of ground
coffee for two cups (~14g.) into the appropriate filter, Pic.
D-5. Use the other part of the measuring spoon to press
the coffee, Pic. D-6. Clean the edges of the filter holder
from the remaining coffee.
The better you tamp the coffee, the darker it will
be, and vice versa.
8. Install the filter holder into the brew unit, Pic. D-4.
9. Take one or two preheated cups and place them under
the filter holder's spout, Pic. D-7.
10. Make sure the indication is lit (not flashing) and press
or
button to make coffee. Coffee will start
pouring into the cups from the coffee outlet.
11. When coffee preparation is completed, the device will
stop pouring coffee automatically. Wait a few seconds,
and then take the cups.
12. Remove the filter holder and clean it from coffee
grounds.
Clean the filter after every use.
NOTE: To remove the filter from the holder, you may
use the measuring spoon or any other filter, Pic. D-8.
, button, the button
. button. Do it only for