Hama 00062713 Mode D'emploi page 16

All manuals and user guides at all-guides.com
LPR/IPP/RAW: Printer protocols, which are required for
use as a printer server.
SMB/FTP: These protocols are required for access to
connected storage media.
If you are unsure, leave the settings as they are.
On this page, you can also specify the mode you want the
device to connect in.
Net USB mode: Connections to the connected USB
device are direct. In other words, while one user is
connected to the device, no other users can access it.
Server mode: In this mode it is possible for multiple users
to access the connected device at the same time, such
as with a connected hard disk.
Switch to the User accounts tab.
4.1.4 User accounts
You can control access to connected USB storage
via user accounts. Users are prompted for their
username and password when you select the option
Activate server authentication on the Supported
protocols tab.
Administrator account:
The most important account for all settings is the
administrator account. By default, the following is
set for the administrator:
Username: admin
Password: admin
To change the login data for the administrator, fi ll in
the following fi elds under Administrator account:
Username: Enter a username of your choosing with a
maximum of 15 characters (letters and numbers are
allowed)
Password: Enter a password of your choosing with
a maximum of 15 characters (letters, numbers, and
punctuation marks are allowed)
Repeat password: Confi rm the password by
repeating it.
After this, click the button Apply. This sets the new
values for the administrator account.
Creating user accounts
You can create up to 25 user accounts. To do so,
proceed as follows:
Fill in the following fi elds under User account list:
Username: Enter a username of your choosing with a
maximum of 15 characters (letters and numbers are
allowed)
Password: Enter a password of your choosing with
a maximum of 15 characters (letters, numbers, and
punctuation marks are allowed)
Permission: This selection decides whether the user
has read only or read and write access.
After this, click the button Add. The user then
appears in the list under the entry fi elds.
Switch to the Maintenance tab.
4.1.5 Maintenance
Restart server: Click this button to restart the USB
Multifunction Server.
Default values: To reload the default settings, click this
button. Alternatively, you can press and hold the Init
button (located on the housing). Disconnect the power
supply unit from the power supply and reconnect it after
a few seconds. You can now release the Init button.
Update system fi rmware: Here you can load a fi rmware
update provided by Hama. Please note that loading a new
fi rmware resets your settings.
15