Jewett-Cameron Adjust-a-Gate Contractor AG36-3 Instructions D'assemblage page 4

STEP 4: ATTACHING YOUR BOARDS
TIP: To hide the gap on the HINGE SIDE of the gate, you may
overlap your fence board to cover this gap. APPLICABLE TO
INWARD SWINGING GATES ONLY
LATCH CATCH ASSEMBLY FOR DOUBLE DRIVE GATES
L
L
©2013-2016 Jewett-Cameron Company • www.jewettcameron.com •
All manuals and user guides at all-guides.com
TIP: It is recommended that your gate boards be cut 2"
shorter than the fence boards to allow the top of your
gate to be even with the fence and allow clearance under
the gate.
Now you can attach the rest of your boards onto the 2x4's
on the gate using nails or screws.
By adjusting the tunbuckle on the truss cable you can fine
tune the gate.
I
4
03-AG1-CONTRACTOR
Customer Service: 800-955-2879
2016-10-21