Brandson Equipment 304523 Mode D'emploi page 21

All manuals and user guides at all-guides.com
4. Initial use
Take the device and all the accessories out of the package and remove the pack-
aging material.
1. Place the soldering iron in the soldering iron holder. Connect the soldering
iron plug to the soldering iron socket.
2. Please ensure that the On/Off switch is switched off.
3. Select the soldering tip appropriate for your work and fix it to the soldering
iron (see Chapter 5 in this user manual).
4. Check if the mains voltage matches the mains voltage indicated on the
specification plate. If so, insert the plug of the soldering station into a
properly installed socket.
5. Moisten the pad and place it in the pad holder of the soldering iron holder.
6. Switch on the device using the On/Off switch located at the back of the
device.
7. Set the desired temperature using the "Temperature potentiometer (5)".
The display shows the set temperature and then the actual temperature
when adjusting.
8. During the heating process, the "HEATING" LED glows continuously. Once
the actual temperature reaches the set temperature, the "HEATING" LED
starts flashing. You can now start the soldering.
English
21