Télécharger Imprimer la page
Chamberlain POWER DRIVE Whisper Drive 956C Manuel D'instructions
Chamberlain POWER DRIVE Whisper Drive 956C Manuel D'instructions

Chamberlain POWER DRIVE Whisper Drive 956C Manuel D'instructions

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Models 956C, 956C-CF, 956C-CN, 956C-RD, 956C-SP
The 900 Series remote control (Security✚
door openers and light controls having an orange "learn"
button and a yellow indicator light.
Programming instructions are described and illustrated
below. The additional push buttons can also activate other
garage door openers and/or light controls. (Instructions for
programming light products are included with those
accessories.)
Instructions are described and illustrated below
1. Press and release the "learn" button on the
motor unit. The learn indicator light will
glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or
keyless entry you wish to use.
To Control the Opener Lights
In addition to operating the door, you may program the remote
to operate the lights.
1. With the door closed, press and hold the remote button that
you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener lights
should turn on or off but the door should not move.
114A2216D
3-Button Security✚
OWNER'S MANUAL
®
) works only with
9
1
9
1
7
3
7
3
5
5
KG
KG
©2006, The Chamberlain Group, Inc.
All Rights Reserved
/
Mini Remote Control
®
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
The Remote Control Batteries
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
The lithium batteries should produce
power for up to 5 years. To replace, pry
open case as shown. Insert batteries
positive side up (+).
Dispose of old batteries properly.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
3V2032 Lithium Battery . . . . . . . . . . . . . . . . . . . . . . .10A20
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-654-4736
WARNING
CAUTION
WARNING
CAUTION
Replacement Parts

Publicité

loading

Sommaire des Matières pour Chamberlain POWER DRIVE Whisper Drive 956C

  • Page 1 3. Press and hold the Lock button on the door control. 4. After the opener lights flash, release all buttons. Test by pressing the remote push button. The opener lights should turn on or off but the door should not move. ©2006, The Chamberlain Group, Inc. 114A2216D All Rights Reserved...
  • Page 2 4. Lorsque l’éclairage de l’ouvre-porte clignote, relâcher tous les boutons. Faire un essai en appuyant sur le bouton-poussoir de la télécommande. L’éclairage de l’ouvre-porte doit s’allumer ou s’éteindre sans que la porte ne bouge. © 2006, The Chamberlain Group, Inc. 114A2216D Tous droits réservés.

Ce manuel est également adapté pour:

Power drive whisper drive 956c-cfPower drive whisper drive 956c-cnPower drive whisper drive 956c-rdPower drive whisper drive 956c-sp