Blaupunkt VIO-DP20 Mode D'emploi page 8

All manuals and user guides at all-guides.com
Step 4:
Use the mounting map sticker, to mark the position of the drilling points.
There are three holes for the screws and a big hole for the ethernet network port and
the camera power connector.
Drill through the 3 small marked points and install the plastic anchors on
Step 5:
the 3 small holes. Then choose one of the option bellow:
•
If the ethernet network port and camera power connector need to exit from the
back of the camera through the installation surface, drill a hole according to the
size of the bigger hole on the mounting map sticker. (For the big hole ideally use a
SDS-max 20mm drill)
•
If the Ethernet Network port and Camera Power connector need to exit from the
side of the camera, the cable must go through the U-shape side exit on dome
pedestal.
NOTE:
If due to special circumstances, such as a reinforced concrete wall, it's not possible
to drill a hole of 20mm diameter, you have the option to cut off the thick Ethernet
Network port - see "Chapter 2. Product Appearance", and seal it with a proper sealing
tape. With this option only a 12mm diameter drill is needed.
Alert: If you decide to cut off the Ethernet Port, you will lose the possibility to connect
the camera by Ethernet cable to a router or NVR. Additionally, you lose your right of
return.
Step 6: Adjust the dome camera according to the mounting map sticker and line
up the three screw holes in the dome pedestal to the three plastic anchors holes. Fix the
three screws in the three plastic anchors firmly.
Step 7:
Use three Inner hex wrench screws to fix the Dome housing on the pedestal.
Step 8:
Connect the Camera Power connector to the included power supply cable.
Then connect the power supply cable to the power line socket. Optional: If you want
to install your camera via Ethernet cable, connect your camera to the router using an
Ethernet cable.
5.3. Installation with mounting bracket (optional)
•
The VIO-DMB1 mounting bracket is an optional accessory purchased separately
from the camera. If you desire to install the camera with the mounting bracket
please refer to the manual inside the mounting bracket box.
8