Publicité
Les langues disponibles
Les langues disponibles
To obtain a forecast with the maximum accuracy allowed by this TempMinder®, you need to input your current weather
condition. When you first power the receiver (or reset the unit in the future), press the + or
-/Zone button to select one of the
weather conditions shown above that most closely resembles your current weather conditions. Press the "CLOCK" button on the
back of the main unit to confirm and exit.
NOTE:
Different geographical locations such as an inland areas or a coastal regions have different weather forecasting responses. In case
your weather forecast always shows the same over a long period of time and does not reflect the actual weather condition, the
following will explain how to institute a reset without completely starting over.
Resetting the Weather Forecast:
Press and hold the "CLOCK" button on the back of the main unit until the time area at the top of the display flashed 12/24H.
Repeatedly press the "CLOCK" button to cycle through the 12/24 H format setting, and calendar settings until the weather icons
(shown above) flash. Press the + or the -/Zone button until the icon that most closely resembles your current weather condition
is displayed. Press "CLOCK" button to confirm and exit back to the normal display mode.
12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > Weather Forecast > + or
-/zone then "clock" to EXIT.
MAXIMUM / MINIMUM MEMORY
Press [MEM] button repeatedly to view the maximum & minimum values of temperature & humidity readings since last cleared.
To clear the memory record, press and hold [MEM] button while each of the respective values are displayed on screen.
TEMPERATURE & HUMIDITY TREND INDICATOR
The icons will indicate Rising, Steady or Falling if the temperature or humidity changes more than 1 degree C (or 2 degree F)
within one hour.
DUAL TIME SETTING
In addition to displaying your normal (local) time, the TempMinder® MRI-193AN is capable of displaying a second "world" time.
To enter a second time, press and hold -/Zone button to enter world (dual) time setting mode. Press + or -/Zone button to enter
the desired hour offset value from –12 to +12 hours. Press [CLOCK] to confirm and exit.
During normal operating mode, press "-/ZONE" button to toggle between home and world (dual) time. The "ZONE" icon appears
when world (dual) time is selected.
ALARM SETTING
Press and hold [ALARM] to enter alarm time setting mode. Press + or -/Zone button to enter the desired Hr/ Min values and press
[ALARM] to confirm setting.
In normal operating mode, press [ALARM] to show the set alarm time. "AL." icon will appear. Press again to enable or disable the
alarm. A bell icon " " appears when the alarm is enabled.
SNOOZE & BACKLIGHT
When the alarm is going off, press [SNOOZE/CHANNEL] button to trigger snooze alarm and "Zz" icon will appear. To stop alarm
for one day, press [ALARM] key.
Press [SNOOZE/CHANNEL] button for an extended backlight (20 seconds) if the AC adaptor is not being used.
If the unit is plugged in (using the AC power adaptor) you may turn the display on and off by pressing the "Light on/off" button.
LOW BATTERY INDICATION
A low battery icon will appear if either the main unit (receiver) or any remote transmitter batteries need replacing.
BATTERY DISPOSAL
Replace only with fresh Alkaline Batteries (Do not use inexpensive carbon batteries or re-chargeable batteries, as they will
diminish the performance of your weather station). If the remote transmitter is to be used in extremely cold weather (below -
20C / -4F), please use Lithium type batteries.
Please dispose of old, defective batteries in an environmentally friendly manner in accordance with local guidelines.
Publicité
