Publicité
Les langues disponibles
Les langues disponibles
Use As A Headlight
4. Assembling the helmet attachment: Insert the clamp onto the base, plug in the
screw, and rotate to tighten as indicated by the diagram.
5. Installing the front light: Clip the light onto the clamp, push it in until a click
sound is heard.
6. Attaching the Velcro: Run the Velcro through the buckle as indicated by the
diagram.
Note:
1. When installing the light, make sure the clamp lift bar is facing backwards.
2. There are four threading slots on the helmet attachment to attach the Velcro at
0 and 90 degrees.
Use As a Flashlight
Besides being a bike front light and a headlamp, this light can also be used as a
handheld flashlight. Attach the wrist sling for better portability.
All manuals and user guides at all-guides.com
2. Installing the Tail Light
1. Locate the placement, wrap the silicone band around the bike frame.
2. Adjust the band, use the white hook to fix in place and adjust the light angle.
3. The tail light can be installed on the seat post, front fork, helmet, and backpack, etc.
How to Use
Front Light
1. Tap the touch power button lightly and remove your hand once the mode is
changed. A prolonged tap will not quickly change the mode.
2. Tap the touch power button to cycle through bright, dim, flash, and off mode.
Note:
The touch power button uses capacitive sensing technology to respond to human
touch as short as 0.6 seconds. It is also responsive to metallic contact. In special
cases when the touch button fails, the light will automatically restore to factory
default settings in 9 seconds. A low battery may also contribute to the low
sensitivity of the touch button. Please charge the light in time when the battery
is low.
07/08
Publicité
