Setting The Temperature; Temperature Display; Electrical Connection - Tintometer Lovibond EX-Serie Mode D'emploi

Appliance dimensions (mm)
A
EX 160 860
EX 220 1250
EX 300 1640
EX 490 1640

Electrical connection

Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion of
direct current to alternating current/three-phase
current) or energy-saving plugs. Risk of damage
to the electronic control system!
Switching the appliance on and off
You are recommended to clean the interior of the appliance before
switching it on for the first time (see Cleaning).
Switching the appliance on
Connect the appliance to the mains - the appliance
is switched on.
Switching the appliance off
Pull out the mains plug or set the temperature
control to 0.
Important
When the temperature control is turned to "0", the refrigera-
tion system is switched off, but the appliance is not completely
disconnected from the mains.
Before cleaning, always disconnect the appliance from the
mains. Remove the plug.
12
B C D
600 600 648 1151
600 610 650 1180
600 610 650 1180
750 730 850 1410

Setting the temperature

Set the temperature inside the appliance using the temperature
control.
The nearer the temperature control is to the max. The nearer the temperature control is to the
colder the interior temperature. colder the interior temperature.
Set the control between "0" and "max." as required.
EX 160
E

Temperature display

The temperature display is powered by a battery which is available
from your specialist dealer.
Changing the battery
• Open the battery compartment using a small screwdriver.
• Replace the battery.
• Close the battery compartment.
If Er or HH appears in the display, the appliance has a fault. Con-
sult the customer serv ice department indicating the fault number
displayed.
EX 160
Safety lock
The lock in the appliance door is equipped with a safety mechanism.
Locking the appliance
• Insert the key as shown by arrow 1.
• Turn the key 90°.
To unlock the appliance, the same procedure must be repeated in
the same order.
EX 160
EX 220 / EX 300 / EX 490
EX 220 / EX 300 / EX 490
EX 220 / EX 300 / EX 490
EX 160 / EX 220 / EX 300 / EX 490_1 03/2014
max. setting, the setting, the