Jata electro BT1022 Instructions D'usage page 10

• Make sure neither the appliance nor the cable are in direct contact with
hot surfaces or objects.
• Always place it on a flat surface.
• Do not leave the blender plugged in if it is not going to be used.
• Take all necessary precautions while handling the blade, as it is very
sharp.
• If the cable were to deteriorate it must be changed by an Authorised
Service Centre
INSTRUCTION OF USE
• Place the jug (3) on the main body (4).
• To do it, place the jug up the main body making coincide the indication (
indication of the body (
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed and
maintain always held while in use.
• Plug the appliance into the mains.
• Push the on pusher (
will light on showing the numbers "00" and the pushers "Continuo" (7), "Inicio/Paro" (8) and
"Selector" (9) will light on as well as the "Mezclar" indicator.
• The blender has two functioning ways. It can work either with a timing count down ( max 120
seconds) or in a continuous way.
ATTENTION
The blender has a security system that switches off automatically the appliance if it is
not used for a period of time of 15 minutes.
TIMING COUNT DOWN FUNCTIONING
• Select by the "Selector" pusher the desired function for the blender. With each pushing the pilot
light will light on indicating the selected functioning. Leave the pilot light on in the desired
position. The highest power is with the "Puré" indication.
• Push "Inicio/Paro". After that its pilot light will be intermittent, the blender will start working,
the display "starts the count down" (120 seconds) and the on pusher (
in a intermittent way will be fixed.
• After 120 seconds, will sound an acoustic signal and the blender will stop. The on pusher (
(6) will change to intermittent and the "Inicio/Paro" pusher will be fixed again.
• If you want to stop the blender before 120 seconds push "Inicio/Paro".
• If you want to switch it on again after finishing the cycle wait at least 1 minute before switching
it on again.
ICE CRUSHING FUNCTION
• That position is ideal for ice-crushing. Press successively the "Selector" pusher until the indicator
is placed in the "Pica Hielo" position. Next press "Inicio/Paro". The blender starts working in
an intermittent way to stop again automatically after passing 120 seconds. For it, we suggest to
use little ice cubes, or you can bit them before putting them on the blender, to avoid the "igloo"
effect. This means that the crushed ice get adhered to the blender walls, and it avoids other ice
cubes to arrive to the base to be crushed.
All manuals and user guides at all-guides.com
.
). Next turn the jug to the (
) (6). This pusher will light on intermittently. At the same time the display
) position until the end to fix it correctly.
10
) of the jug with the
) (6) that it worked
)