Allen-Bradley 6181 Notice D'installation page 17

4. Install the mounting clips. The mounting clips slide into the slots on
the top and bottom of the 6181 Computer.
Mounting
Clip
5. Gradually tighten the clips one at a time around the bezel using the
specified sequence. Repeat this process at least three times until the
clips are hand-tight and the gasket is compressed uniformly against the
panel.
6. Tighten mounting clips to a torque of 10 in–lbs (1.1 N•m) in the
sequence shown above. Do not over–tighten.
All manuals and user guides at all-guides.com
6181 Industrial Computer
Publication 6181-IN002C-MU-P
17