UFESA exprimidor EX4970 Mode D'emploi page 13

All manuals and user guides at all-guidesbox.com
INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all the product' s packing has been removed
Before using the product for the first time, clean the parts that will come in contact with food as described
in the cleaning section.
Warning: End the pressing before the juice reaches the bottom edge of the motor base.
ASSEMBLY:
Place the filter in the juicer container.
Fit the juicer cone on to the drive shaft.
Insert the plug into a suitable wall socket.
Important: To avoid damage to unit, stop the operation for approximately 10 minutes after pressing/
juicing 10 pieces of oranges or other citrus fruit.
Making juice using the glass jar
The motor base has to be place onto the glass jar.
Slice the citrus fruit in half. Place the half (cut side down) onto the juicing cone.
To start juicing, simply lower the lever onto the juicing cone with fruit, and make sure the juicing cone lid
is in full contact with the citrus fruit.
The appliance switches off when pressure on the cone is lifted.
When processing larger quantities of fruit, the filter must be emptied from time to time as necessary.
Disconnect the appliance from the main.
Remove the motor base from the glass jar and serve.
If you want to store the juice, you can seal the glass jar with the lid (8).
Warning: End the pressing before the juice reaches the bottom edge of the motor base.
Making juice without the glass jar
Once you press a small quantity of juice (for seasoning food for instance), the juice is collected in the
container.
The volume capacity of the container is approx. 60ml.
Stop pressing before the juice reaches the top edges of the container.
Disconnect the appliance from the main.
CLEANING
WARNING: Do not immerse the motor base, cord or plug in water or any other liquid.
Do not use abrasive cleansers.
Dishwasher safe parts:
- Filter
13