Publicité
FUNCTION
POWER
HEATER
ECO
BOOST
TIMER
BRIGHTNESS
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
ICON
DESCRIPTION
This button will not only put the fireplace insert in a standby mode, but also you can
see the flame effect through the screen. This will turn off all functins at once.
Note: Holding the POWER button for 3 seconds will turn on the Child safety lock. It
disables or enables all functions on the control panel and remote control.
The fireplace contains a fan forced heater.
The default setting temperature is 72°F (22°C).
The thermostat setting range is 50°-86°F or 10°-30°C.
The thermostat is adjustable by 2°F or 1°C increments.
To change between °F and °C press and hold the HEATER button for 5 seconds.
Press the ECO button when the heater is on, to run the heater in a reduced wattage
range.
Note: Holding the ECO button for 3 seconds disables any heater functions.
To quickly heat up a cold room/space, press the BOOST button to run the heater at
the full rated wattage.
Pressing the BOOST button repeatedly will cycle through the following boost settings:
5 minutes, 10min, 15min, 20min, 25min, 30min and off.
Pressing the timer button repeatedly will cycle through the following timer settings:
30 minutes, 1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr, 8 hr and off.
The fireplace will automatically turn off when the timer reaches zero minutes.
This button controls the brightness of the flame effect.
E-4
Publicité
