Publicité
Les langues disponibles
Les langues disponibles
Assembling and Installing Your Gate
NOTE: You will notice a slight gap between the gate door latch and the frame. This is not a
defect. Your gate is a pressure mounted gate and this gap will disappear once you tighten
your gate in its opening.
STEP 1
Locate the (4) threaded spindle
rods. Rotate the adjustment wheels
along the threading, eliminating
the gap between the adjustment
wheel and the rubber foot.
STEP 2
Insert the (4) threaded spindle
rods into the holes at each of the
four corners of the gate.
NOTE: The ends of the gate frame are not threaded. The threaded spindle rods should slide
into the end of the frame tubes without any resistance.
All manuals and user guides at all-guides.com
ADJUSTMENT WHEEL
RUBBER FOOT
ENGLISH
5
Publicité
