monte carlo MC237 Serie Instructions D'installation page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
4
Tap
Remove tap from bottom of switch housing.
Thread lead wires from light fixture through
central hole in switch housing and then
install switch housing onto light fixture by
turning clockwise till tight.
7
Show different
types of plug
Lift light fixture assembly up, connect
the plug from fan to the plug from
light kit assembly. Make sure the
plugs are clasped firmly.
© 2014 Monte Carlo Fan Company
GENERAL INSTALLATION
2
Remove set screws from switch housing.
Keep screws.
Switch housing may be different than
shown.
5
Hex nut
Lock washer
Light fixture
Place lock washer and hex nut provided
over lead wires from light fixture and tighten
securely with the thread rod of light fixture.
8
Install light kit assembly (switch
housing) onto the fan with set screws
removed in step 2.
3
Switch housing
Switch
housing
Unplug (If wiring with plugs) and remove
the switch housing from fan.
6
Connect white wire from light fixture
with white wire from switch housing
(or fan) and then connect black wire
from light fixture with black (or blue)
wire from switch housing (or fan).
3
Switch housing, plugs may be
different than shown
10/6/2014