Publicité
Les langues disponibles
Les langues disponibles
To operate the tilt mechanism :
I.
Unlock by loosening both "T" knobs (without removing them).
2. From inside the cab, gently tilt out (both side at the same time) the windshield to the desired
position. Note that there are 3 pre-detennined positions on the slide ann; closed, half-opened
and fully-extended
3. Lock in place by tightening back both "T" knobs.
To remove the windshield :
With TWO people, remove both "T" knobs and follow reverse instructions 4, 3 & 2 of step #d).
The tilt mechanism is designed for cooling the airflow in warm temperatures. Note that any open positions
At HIGH SPEED RIDING or when TRANSPORTING the vehicle, the windshield must be CLOSED.
High speed running or trailering with windshield open may cause failure and is not covered by any
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
• Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO
• Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
• To remove wet paint, glazing compound or grease, rub lightly with a good grade ofVM&P naphtha or isopropyl alcohol,
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual
I __ Fantastik __ 1 _ __ Jo z_ __ _ 1 __ Formula409 __ 1 __ Mr.Oun __ 1 __ T '!l' Job __ I_VM&P _g rad,N '!(' htha
\'ll,l,',GWSIOOO" Instructions YAMAHA VIKING Full Tilt Wiodshield. rev01
IMPORTANT NOTICES
are designed for LOW-SPEED operation ONLY.
warranty.
CLEANING:
NOT SCRUB or use brushes or squeegees.
then wash and rinse. DO NOT USE GASOLINE.
hazing, loss of light transmission and coating delamination.
Compatible Cleaning Agents
•
Aqueous Solution of Soaps and Detergents
:
llucrl,F.O.SS4
I
_11'<1,co-Placrr _ I
I
_
wvvV1.direction2.com
4
Publicité
