Delete Remote Controller; Coding Of Defense Zone - Evolu7 Solar Guide D'utilisation

on without flashing; press any button on the wireless remote controller,
the main unit makes a long beep and you will hear "coding completed",
[ ] indicator goes out, indicating the remote controller succeeds in
coding.
Operating method: [20]  [A]  [#]
A indicates: 1~8 remote controllers number. You can add maximum 8
remote controllers.
LCD display:

35. Delete Remote Controller

The remote controller can't control the main unit after it's deleted.
In setup state, use keypad to input [21], then input the remote controller
number [1-8], and then press [#] to confirm. The main unit emits a long
beep and the [Signal] indicator flickers once. You will hear a voice
prompt "delete completed".
Operating method: [21]  [A]  [#]
A indicates: 1~8 remote controllers number.

36. Coding of Defense Zone

Wireless detectors have to be coded to the main unit in order to trigger it
alarm. The wireless PIR and door sensor in the standard package have
been coded.
In setup state, use keypad to input [23], input the defense zone number
you want to code [01~99], and then input [#] to confirm. The main unit
emits a long beep and the corresponding defense zone is displayed on the
screen. You will hear a voice prompt "detector coding". Then trigger a
wireless detector to emit a wireless signal; after receiving the signal, the
main unit makes a long beep, and you will hear "coding completed", the
[ ] indicator goes out at the same time.
Operating method: [23]  [XX]  [#]
XX indicates: 01 ~99 defense zones number
LCD display:
59