Lascar Electronics EL-USB-TC-LCD Guide D'opération page 9

9
E E L L - - U U S S B B - - T T C C - - L L C C D D
S S T T A A T T U U S S I I N N D D I I C C A A T T I I O O N N
L L E E D D G G r r e e e e n n d d o o u u b b l l e e f f l l a a s s h h
Every 20 seconds: logger full, no alarm
I I n n d d i i c c a a t t o o r r s s
G G r r e e e e n n s s i i n n g g l l e e f f l l a a s s h h
Every 30 seconds: delayed start
Every 20 seconds: logging, no alarm, low battery
Every 10 seonds: logging, no alarm
R R e e d d / / G G r r e e e e n n s s i i n n g g l l e e f f l l a a s s h h
Every 20 seconds: logger full, last value equal
to or exceeds the low or high alarm
R R e e d d d d o o u u b b l l e e f f l l a a s s h h
Every 10 seconds: logging, high alarm
Every 20 seconds: logging, high alarm, low battery
R R e e d d s s i i n n g g l l e e f f l l a a s s h h
Red LED Gree LED
Every 10 seconds: logging, low alarm
Every 20 seconds: logging, low alarm, low battery
N N o o L L E E D D s s f f l l a a s s h h
LEDs disabled during configuration to save
battery power and increase logging life /
logger stopped /battery empty
All manuals and user guides at all-guides.com
E E N N
L L C C D D I I n n d d i i c c a a t t o o r r s s
Temperature scale
symbol
Reading Maximum/Minimum
logged value symbol
The EL-USB-TC-LCD features a high contrast LCD and
two LEDs. The LCD shows the latest logged reading,
maximum, minimum and supplementary details on the
logger status (see table opposite).
Distributed by MicroDAQ.com, Ltd.
Logger status
Display
Delayed Start
Push to Start
Logging
Stopped
*If the logger is set to 'LCD off' or 'LCD on for 30 seconds' mode, then this will only be shown after
the button is pressed. Otherwise the display will remain blank.
www.MicroDAQ.com (603) 746-5524
Explanation
This is shown when the logger is set to
start at a specific date and time *
This is shown when the logger is setup for
'push to start' logging
This is shown when the logger is running
in 'LCD off' mode, and the button is
pressed. The display clears again after
three seconds
If the logger has not been set to log and
the button is pressed, three dashes are
displayed for three seconds
10