CEBEK I-14 Guide Rapide

You can adjust the brightness of any lamp up to 500 W. Includes connection terminals.
POWER . 230 V AC. for proper operation. Install a fuse and a switch that are necessary for the protection and
safety, as reflected in the CE standard.
OUTPUT CONNECTION. LOAD. Just admit resistive loads such as light bulbs, resistors, stoves, etc.
You can not regulate inductive loads such as fluorescent, halogen lamps, LED lamps, transformers, etc..
To connect the output you have to connect the bulb to terminal.
OPERATION. Once you have completed and verified the connection to the input and the output, you can activate the
switch supplying the current, and by the potentiometer you can adjust the brightness of the output. If regulates the
potentiometer to the left, lower the intensity. If it regulates to the right increases the brightness.
INSTALLATION. Install in a box for proper protection. During operation, dissipates a lot of heat, must be in a
sufficiently ventilated box.
ATTENTION: 230V CIRCUIT IN SEVERAL POINTS
Vous pouvez régler la luminosité d'une lampe jusqu'à 500 W. Comprend bornes de raccordement.
ALIMENTATION . 230 VAC pour un fonctionnement correct. Installez un fusible et un interrupteur qui sont
nécessaires à la protection et à la sécurité, comme en témoigne la norme CE.
REGULATEUR DE LUMIERE
REGULADOR DE LUZ
REGULADOR DE LLUM
www.cebek.com -
LIGHT REGULATOR
500 W
I-14
TECHNICAL CHARACTERISTICS
Operating Voltage : 230 V. A.C.
Minimum Operative Load : 50 W.
Maximum Consumption : 500 W.
Power Variation : From 3% until 98%.
Size : 72 x 53 x 26 mm.
Weight : 36 gr.
Din rail : C-7563
sat@fadisel.com