Publicité
Les langues disponibles
Les langues disponibles
5.
Remove the junction box cover.
Carefully remove the knockouts for
AC line input wires and 0-10V
control line. Install listed electrical
fittings in the knockout holes for
wire protection if needed.
-
Suspended mounting
1.
Replace the existing earthquake tabs with the
provided brackets which are used for fixing
adjustable cables.
General Wiring Diagram
4114511
6.
Plug in AC line (L, N and GND) to
the LED Driver using 18-14AWG
Wire.
1.
2.
Insert the end of cable A into the hasp attached on the cable B,
then adjust the cable A to be desired height and adjust the cable B
to the desired angles.
2.
Hook the luminaire up to the hooks attached to the other end of
cable B and make a final adjustment.
3.
Connect LED driver to AC mains power.
Publicité
