Coccolle ELONA iSize 100-150 CM Mode D'emploi page 7

EN
Use Belt Only
1. If the seat cannot be used in combination with ISOFIX anchorage points in
the vehicle seat, the ISOFIX attachments can be stowed inside the seat and the
seat can be used in combination with the 3-point belt only.
2. Position the seat inside the vehicle. Slide the shoulder belt in the shoulder
belt guide. (fig.5) Make sure the belt is not twisted.
Positioning of the child
1. Adjust the headrest to the correct height by squeezing the Height adjuster.
(fig.6) The headrest must be adjusted so that there is a space two fingers wide
between the headrest and your child's shoulders. (fig.7)
2. The seat can be fixed in 2 positions by sliding out the reclining Handle at the
bottom of the base. Position the seat in the correct position before positioning
the child with the vehicle belt. (fig.8)
3. Position the vehicle belt in front of the child and lock the belt into the buckle of
the vehicle. (fig.9)
Removing the seat
1. Remove the shoulder belt out of the shoulder belt guide. (fig.10)
2. Squeeze the ISOFIX release button to release and pull back the ISOFIX
attachments. (fig.11)
3. Remove the seat from the vehicle.
Removing and refitting the cover
• Do take care when you remove the cover, as re-fitting the cover is the reverse
process.
• Start to take off the backrest part first and re-fit the backrest part as the last
part.
• For washing instructions, see the wash care label at the inside of the fabric
cover.