Bercomac 108926 Manuel D'installation page 8

WINCH CONTROL MODULE INSTALLATION
This module prevents winch control locking when the cable is rolled backwards on the winch drum.
NOTE: Use this instruction sheet to install the winch control module on new or existing subframes with electric
lift.
IMPORTANT: Disconnect the vehicle battery before installing the winch control module. Always follow the ins-
tructions and precautions of the subframe and vehicle manuals.
Identify each wires:
Install on winch's toggle
switch wires
Black wire, ring terminal
Install on winch's relay
Green wire,
female flat terminal
FI_108926
PRODUCT # 108926
Black wire,
male round terminal
Instruction Sheet
Green wire,
female round terminal
Fuse not
shown
Red wire,
male round terminal
Black wire,
female round terminal
Install behind winch's
toggle switch
Red wire, male and
female flat terminals
Install on winch's limit
switch wires
Red wire,
male flat terminal
R-11232017