Publicité
Les langues disponibles
Les langues disponibles
BLOWER ORIENTATION
IMPORTANT: Be sure the blower is correctly orientated. Note arrow
on the side of the blower housing indicating the correct air flow
direction (FIGURE 4).
FIGURE 4 – VERTICAL DISCHARGE
VERTICAL
DISCHARGE
VENT
(TOP OF HOOD)
CLEANING INFORMATION
FILTER
For greatest efficiency, the aluminum filters should be removed and
cleaned periodically. To remove the filters, loosen the screw in the
center of each filter.
To clean, the filter should be soaked in hot water and detergent then
thoroughly rinsed. The aluminum filter can be cleaned in a dish-
washer.
EXTERIOR SURFACE
To preserve its lasting beauty, clean with a mild detergent. DO NOT
use abrasive cleaners.
MOTOR SPEED
TROUBLESHOOTING
If you have a motor speed problem, please check the following list
for possible troubles.
1. Blower assembly installed wrong - instended for vertical dis-
charge, but installed for horizontal discharge (FIGURE 4).
2. Damper flap - not opening.
3. Reduced airflow because the duct is too small, too long, or has
too many transitions in the system.
4. Restriction in the duct (foreign matter, debris).
5. Undersized or restructive roff or wall cap.
6. Damper flap in roof or wall cap - not opening.
7. Wait for 20-30 seconds between speed changes for RPM to
adjust.
By removing or correcting these adverse factors, the motor speed
control will be able to decrease from maximum RPM.
All manuals and user guides at all-guides.com
REPLACEMENT PARTS LIST
FIGURE 5
BLOWER
DISCHARGE –
LOCATE AT
DISCHARGE
VENT IN TOP
OF HOOD
THIS
SURFACE
TO REAR
TO CHANGE LIGHT BULB
Remove lens cover by squeezing the retention tab and rotating the
lens out. Remove old bulb and replace with a 75-Watt (maximum)
bulb. Replace lens cover.
3
Part No.
Description
R561107
3-Pos. Rotary Light Switch
R567073
Motor, Speed Control
R730079
Blower Assembly
R610080
Filter
R610081
Filter (combination) used with 355NDK Kit
R566066
Lampholder
R520098
Motor
R531041
Blower Wheel CW
R531042
Blower Wheel CCW
97013316
Light Lens
355NDK
Non-Duct Recirculation Kit (optional accessory)
LAMPHOLDER
MOTOR
CONTROL
BLOWER
MOTOR
WHEEL
CW
FILTER
JUNCTION
BOX
LIGHT
SWITCH
BLOWER
WHEEL
CCW
BLOWER
ASSEM-
BLY
BLOWER
COVER
BLOWER /
LENS COVER
SCREW
LIGHT
LENS
Publicité
