Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
KitchenAid
Water Filtration
and Monitoring System
(on some models)
The water filter indicator light
The water filter indicator light will help you know when to
change your water filter cartridge. The light is located at
the inside top of the refrigerator compartment. The light will
change from green to yellow. This tells you that it is almost
time to change the water filter cartridge (90% of the filter
life has been used). It is recommended that you replace
the water filter cartridge when the water filter indicator
light changes to red OR water flow to your water dis-
penser or ice maker decreases noticeably. (See
"Changing a water filter cartridge" later in this section.)
NOTE: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system.
AquaSense
Monitoring System
Filter Indicator Reset
Filter Indicator
Green - Good Filter
Push light switch 5 times in 10 seconds
Yellow - Order Filter
to reset filter indicator to green
Red - Change Filter
After changing the water filter cartridge, reset the water
filter indicator light by pressing the light switch 5 times
within 10 seconds. The indicator light will change from red
to green when the system is reset.
Changing a water filter cartridge
The water filter is located below the freezer compartment
door.
1. Locate the water filter cartridge cap in the front base
grille below the freezer compartment door. Rotate the
cap counterclockwise to a vertical position and pull the
cap and filter cartridge out through the base grille.
NOTE: There will be water in the cartridge. Some
spilling may occur.
2200285A
AQUASENSE √
*
*
2. Remove the cartridge cap by sliding it off the end of
the old cartridge. The cap will slide to the left or right.
DO NOT DISCARD THE CAP.
3. Take the new cartridge out of its packaging and
remove protective cover from o-rings.
4. Slide the cartridge cap onto the new cartridge as
shown.
5. With cartridge cap in the vertical position, push the
new filter cartridge into the base grille until it stops.
Rotate the cartridge cap clockwise to a horizontal
position.
6. RUN WATER THROUGH THE DISPENSER UNTIL
THE WATER RUNS CLEAR (ABOUT 2 TO 3 GALLONS
OR 6 TO 7 MINUTES). This will clean the system and
clear air from the lines. Additional flushing may be
required in some households.
NOTE: As air is cleared from the system, water may
spurt out of the dispenser.
NSF
NSF is a registered trademark of NSF International
®
Continued
Publicité
Sommaire des Matières pour KitchenAid AquaSense
- Page 1 KitchenAid AQUASENSE √ 2. Remove the cartridge cap by sliding it off the end of the old cartridge. The cap will slide to the left or right. DO NOT DISCARD THE CAP. Water Filtration and Monitoring System (on some models)
- Page 2 Using the dispenser without the water filter You can run the dispenser without a water filter cartridge. Your water will not be filtered. If you run the dispenser without a water filter cartridge, keep the cartridge cap and replace it in the base grille for future use. 1.
- Page 3 Le filtre à eau est situé sous la porte du compartiment et de contrôle d ’ eau congélateur. 1. Repérer le couvercle de la cartouche de filtre situé AQUASENSE √ KitchenAid dans la grille supérieure avant, sous la porte du compartiment congélateur. Tourner le couvercle dans le sens inverse des aiguilles d’une montre jusqu’à...
- Page 4 être au même niveau que la grille inférieure. 6/98 2200285A *Marque déposée de KitchenAid U.S.A. Emploi Licencié par KitchenAid Canada Printed in U.S.A. © 1998 KitchenAid *Registered Trademark/Trademark of KitchenAid U.S.A., KitchenAid Canada licensee in Canada Imprimè aux É.-U.