Risco Beyond Wireless DT Mode D'emploi page 9

Step 6: Performing a Walk Test
The detector automatically enters walk test mode for 10 minutes following tamper
closure. Walk through the entire protected area and observe the LEDs to confirm full
coverage (see LED Status).
Manually initiate a walk test:
Select User Menu: 5) Maintenance > 1) Walk Test > Select Full Walk Test or Quick Walk
Test. The detector remains in walk test mode until any key on the panel is pressed.
Note: The LEDs switch off after Walk Test to avoid a situation of mapping the detection
zone and to extend battery life.
Step 7: MW Range Adjustment
1 Over power
2 Under power
3 Correct adjustment
Anti-Mask Calibration
Following tamper closure, the anti-mask calibration procedure begins (up to 2 minutes). For
successful calibration, make sure that there are no objects near the detector for the duration of the
procedure.
Figure 10
A Detector
B Corridor
1
2
1
2
A
3
9
B