Publicité
Liens rapides
Vroom 24 Product Cabinet Installation
1.
Locate cardboard
template inside
the cabinet.
2.
Place mounting
bracket in tem-
plate.
Secure with 5
screws as
shown.
3.
Remove the
cardboard
Template.
4.
Install the side
panel. Flex it so
the edges tuck
under the 5 plastic
molded tabs.
5.
Install the Product
in the mounting
bracket by push-
ing it into place as
shown. It will
snap in place
when installed
correctly.
6.
Connect the
vacuum tubing to
the Product's
connector on the
back as shown.
Do NOT glue,
press fit only.
8.
Connect the low
voltage wires on
the back of the
unit.
IH-109-CE
08/2012
Publicité
Sommaire des Matières pour Vroom 24
- Page 1 Vroom 24 Product Cabinet Installation Install the Product Locate cardboard in the mounting template inside bracket by push- the cabinet. ing it into place as shown. It will snap in place when installed correctly. Place mounting Connect the bracket in tem- vacuum tubing to plate.
- Page 2 Vroom 24 Instalación del gabinete del producto Vroom 24 Installation de l’appareil dans un placard Lateral izquierdo de la plantilla Instale el producto Côté large du gabarit Installer l’appareil Coloque la Placer le gabarit contra la pared en el soporte de...